- Designed and built in Newcastle, NSW Australia
We install chainwire fencing across The Junction for property borders, access lanes, and public-facing zones. Each setup is built around site layout, movement type, and usage.
We install fencing across private, shared, and commercial spaces throughout The Junction. Each job is planned based on the shape of the block, use of the area, and the type of movement expected. We use mesh and posts suited to boundary control, access separation, or public-facing applications.
Both galvanised and PVC-coated mesh are available. Posts are set to resist movement on paved, grass, or compacted surfaces. We apply bracing and tensioning to keep the fence line clean and prevent mesh shift over time.
Gates are selected based on access width and traffic type. Whether pedestrian or vehicle, we size and fit gates to suit without restricting space.
Mesh types and fittings are selected based on how the space is used and what level of movement or visibility is required.
Used for defining boundaries or marking off lower-use areas. Common in yards or rear lanes.
Used for extra strength around access points, depots, or storage areas.
Installed for tighter access control—common near storage units, entry points, or restricted areas.
Fitted for short-duration builds, event zones, or layout changes on small worksites.
Manual or sliding gates for controlled entry across footpaths or vehicle points.
Fencing adjusted for tight access spaces, including side walkways or shared-use lanes.
We begin each install with a site walkthrough to review access points, ground levels, and existing features. In The Junction, that often includes side entries, building edges, bin zones, and shared parking areas.
Post positions are mapped to avoid structures, vegetation, or existing hard surfaces. We ensure gates open fully without obstruction and allow clear movement through the space.
Once layout is approved, we prep materials to match slope, length, and spacing. On install, we adjust in real time to maintain even tension and match the site’s final use.
Properties in The Junction often include tight laneways, angled rear blocks, or spaces shared between buildings. These need fencing that doesn’t block access or interfere with how the area is used.
We adjust post spacing and mesh fitment to align with entry points, gates, and walk paths. This includes ensuring bins, tools, or stored items remain accessible after install.
Mesh tension is controlled to remove gaps at ground level, especially in areas with slope or uneven surfaces. Gates are placed with clearance so they function without drag or swing interference.
We install chainwire fencing across The Junction and nearby areas. Whether you’re fencing a side lane, boundary edge, or public-facing access point, we help match the design to how the block is used.
Nearby Areas We Also Service:
Yes. We install mesh and posts to suit tight boundaries, shared driveways, or foot access between buildings.
We offer sliding, hinged, and manual latch gates. Each is sized based on access use and available space.
Yes. We anchor posts into hard surfaces using approved depth and fitting standards.
We offer coated mesh options to reduce corrosion where salt air or sea spray is present.
Yes. We design the layout to keep bins and utility access clear and easy to use.
We’ll inspect the block and suggest the best fit.
